1.Be aware of local weather conditions:
Fog is often a morning or evening weather phenomena, so if possible, avoid driving during these times. Also be aware of local areas that tend to accumulate fog, like certain seaside areas, and other low lying areas near lakes and rivers or wide open places.
2.Allow more distance between vehicles:
Increase your count distance by 5 seconds instead of the normal 2 seconds behind another vehicle. Never rush or speed to get out of the fog.
3.Use caution at all times:
The moisture in the air may continuously collect on the windshield, making it more difficult to see. Adjust the defroster and windshield wiper speed as necessary.
4.Use fog lights or driving lights:
Many vehicles have fog or driving lights that were installed at the factory. These lights are usually mounted low, in or below the front bumper. They are aimed toward the ground out in front of the vehicle as far as possible. Fog lights mainly differ from driving lights in the way they project the light. Fog lights often have clear or yellow lenses; while driving lights usually have clear lenses. The beam of light created by fog lights is usually wide and flat pattern; flat to stay close the road surface and minimize reflection back by fog – and wide to better illuminate the sides of the roadway (guard rails, curbs, lines painted on the roadway, etc.). Driving lights are usually merely bright spot lights designed to pierce the night darkness further than regular headlights. While fog lights are best for foggy conditions, either type of light will likely perform better than headlights due to their low mounting point on the vehicle. Experiment using all combinations (if possible) of fog / driving lights “on” and the low beam headlights “on” or “off” to determine which setting provides the best forward visibility for the driver. Do not shut off the running or “parking” lights, as they help make your vehicle more visible to other drivers alongside and behind your vehicle.
5.Use your low beams:
The visibility in front of you will sharply decrease in a fog, so use the vehicle’s low beam lights (if the vehicle does not have fog lights or driving lights). Heavy fog conditions prohibit use of high beam headlights. The light from high beam headlights will be reflected back by thick fog. As fog thins, high beams can become more effective. Check periodically to see if the fog has thinned enough to make use of high beams.
6.Pull over to the side of the road if you have no visibility:
If it gets too difficult or thick, pull over and wait. Turning on your hazard lights alerts other drivers of where you are.
7.Use the right edge of the road as a guide:
This can help you avoid running into oncoming traffic or being blinded by oncoming headlights.
8.Ask for help:
Don’t be afraid to ask your passengers to help keep an eye out for oncoming cars and obstacles on the road.